Упрощенная HTML-версия
67
Ø 130
Ø 220
88
26
3
185
26
4
Ø 110
Ø 200
Ø 80
Ø 150
Check that diffuser’s
temperature “T max °C”
(tested at 25°C)
complies with your local
regulation
Dimensions
ü Recessed luminaire for outdoor installation in the ground.
ü Configuration: 316 deep-drawn stainless steel structure with milled
AISI 316L stainless steel finish frame.
ü Tempered transparent or sandblasted glass, moulded silicone
gasket.
ü The stainless steel structure allows installation on extreme
conditions (sea or road salt).
ü Protection Rating: IP67
ü In compliance with EN 60598-1 standards
ü Class of insulation: mains:I, low voltage: III
ü Installation:
Ø220mm version: the luminaire is equipped with M20x1,5 plastic
cable gland and a piece of cable for an easy-to-make connection.
Ø130mm version: the luminaire is equipped with M16x1,5 plastic
cable gland (<4,5ø<10mm) and a piece of cable for an easy-to-make
connection. LEDs version is equipped with a hight efficient converter
PWM(Pulse Wide Modulation) that guarantees the right power
supply to the LED module, removes electromagnetic interference
and allows parallel wiring. Idra LED ø130 is protected against polarity
reversal and it is equipped with a piece of cable for an easy-to-made
connection (please provide effective insulation on the connection).
ü Outdoor use requires suitable flexible cables assuring the
watertightness of the cable gland. Installation requires a dedicated
box for installation (to be ordered separately). It is important to
provide a >400mm gravel layer or a drain system (for concrete
surface) to ensure good drainage and to avoid water stagnation.
ü Warning! Use IP68 connectors to avoid water ingress from the cable.
Idra
0. Inox
Remote device required
Do not install in
hollow areas
Installation requires a
40cm water drainage
layer (gravel)
Pre-wired with approx
250mm of cable
Protection against
impact.
IK 09 - 10,00 joule
kg
5kN
50Nm
Static load: 2000Kg
walk over
Drive over
123
2013