Упрощенная HTML-версия
67
Ø 220
219
4
Ø 210
Ø 150
Dimensions
ü Recessed round luminaire for outdoor installation in the ground.
ü Configuration: die-cast aluminium structure. EN AB-47100 (low
copper content)
ü Double layer coating for high resistance to corrosion: chemical
conversion coating on the aluminium surface followed by a first layer
of epoxy powder and a second finishing layer of polyester powder.
ü AISI 316L stainless steel or aluminium frame.
ü Tempered transparent or sandblasted glass (no-slip glass VA on
request) and moulded silicone gasket.
ü Protection Rating: IP67
ü In compliance with EN 60598-1
ü Class of insulation: I
ü Installation: the luminaire is equipped with M20 plastic cable
gland (<ø13mm) and a piece of cable for an easy-to-make
connection. Outdoor use requires suitable flexile cables assuring the
watertightness of the cable gland. Installation requires a dedicated
box to be ordered separately. It is important to provide a >400mm
gravel layer or a drain system (for concrete surfaces) to ensure good
drainage and to avoid water stagnation.
ü Warning! Use IP68 connectors to avoid water ingress from the cable.
Petra
1. White
2. Aluminium 3. Anthracite
9. Rust-red
0. Inox
4. Black
Do not install in
hollow areas.
Installation requires a
40cm water drainage
layer (gravel)
Pre-wired with approx
250mm of cable
Protection against
impact.
IK 09 - 10,00 joule
kg
5kN
50Nm
Static load: 2500Kg
walk over
Drive over
Check that diffuser’s
temperature “T max °C”
(tested at 25°C)
complies with your local
regulation
154
2013