Упрощенная HTML-версия
67
Check that diffuser’s
temperature “T max °C”
(tested at 25°C)
complies with your local
regulation
310
250
117
Ø 250
Ø 310
117
117
117
Dimensions
ü Recessed luminaire for outdoor installation in the ground where
recessing depth are limited (up to 120mm)
ü Configuration: die-cast aluminium structure. EN AB-47100 (low
copper content) in round and square version.
ü Double layer coating for high resistance to corrosion: chemical
conversion coating on the aluminium surface followed by a first layer
of epoxy powder and a second finishing layer of polyester powder.
ü Tempered transparent glass with silkscreen border , AISI 316L
stainless steel frame, moulded silicone gasket.
ü Protection Rating: IP67
ü In compliance with EN 60598-1 standards
ü Class of insulation: I
ü Installation: the luminaire is equipped with M20 plastic cable gland
and a piece of cable for an easy-to-make connection.RGB version:
wiring through two M20 plastic cable glands (<ø13mm). Outdoor
use requires suitable flexible cables assuring the watertightness of
the cable gland. Installation requires a dedicated box to be ordered
separately. It is important to provide a >300mm gravel layer or a
drain system (for concrete surfaces) to ensure good drainage and to
avoid water stagnation.
ü Warning! Use IP68 connectors to avoid water ingress from the cable.
Cassiopea
Do not install in
hollow areas.
Installation requires a
30cm water drainage
layer (gravel)
Protection against
impact.
IK 09 - 10,00 joule
kg
5kN
50Nm
Static load: 2000Kg
walk over (round version)
Static load: 3000Kg
walk over (square version)
Drive over
Pre-wired with approx
250mm of cable
0. Inox
RGB
Version
RGB
Version
175
2013