Стр. 45 - ARES

Ø 34
44
Ø 34
45
Ø 36
42
kg
67
+ + - - - - + + +
-
POWER
SUPPLY
+ + - - - - + + +
-
POWER
SUPPLY
Wiring diagram Anita 350mA
Feeding through a constant current 350mA electronic power supply only (350mA max).
The luminaire allows a series connection only (no parallel connection allowed)
Wiring diagram Anita 12÷24V
Feeding through a constant voltage 24V power supply only (12-24V).
Use dedicated power supplies only.
The luminaire allows a parellel connection only (no series connection allowed)
Dimensions
Do not install in
hollow areas.
8. Anodized
Aluminium
Installation requires a
20cm water drainage
layer (gravel)
Recessed wall fitting
Pre-wired with approx
200mm of cable
Remote device required
Check that diffuser’s
temperature “T max °C”
(tested at 25°C)
complies with your local
regulation
Static load: 500Kg
walk over
Protection against
impact.
IK 09 - 10,00 joule
Box for recessed
installation in concrete
ceiling
ü Recessed luminaire for outdoor installation in ground, wall and
ceiling.
ü Configuration: turned aluminium body (EN 6060) with 15 micron
anodizing for high resistance to corrosion.
ü Opal or transparent polycarbonate diffuser (semispherical or flat)
with silicone gasket and anodized aluminium cap or frame.
ü Protection Rating: IP67
ü In compliance with EN 60598-1 standards
ü Class of insulation: III
ü Installation: Anita is equipped with a piece of bipolar cable (200mm)
for an easy-to-make connection. Installation requires a dedicate box
to be ordered separately.
ü Warning!Use IP68 connectors to avoid water ingress from the cable.
Anita
850°C
Glow wire test: 850°C
45
2013