Упрощенная HTML-версия
430
Isotera - Contactless LED Driver System
Isotera product range
The key elements of an Isotera installation is a LED luminaire connected to a coupler, rather than a driver. The coupler
clips on to an orange cable and power is provided centrally by the power hub. Additionally, control is a simple ‘plug
and play’ add-on using control cables.
Power hub
An ultra-efficient bulk power converter which converts 230V AC mains into a low voltage high frequency AC (HFAC)
which is then fed to the orange twisted pair bus..
Coupler
For delivering constant-current power to the LED luminaires. 15W, 30W and 50W versions available with a range of
output currents.
iBus
A double-insulated twisted pair cable, connected at one end to the power hub and the other end shorted by an
Insulation Displacement Connector (IDC) allowing the connection of mutiple LED luminaires of various drive currents.
The orange cable is double-insulated, LSOH, and supplied pre-fitted with the connector for rapid connection to the
power hub.
Emergency 3 hour module
Battery back-up, charging and selftest according to EN 62034.
Sensor
For occupancy / absence and daylight-linked dimming.
RJ-11 cables and connector
Quick and simple connection of controls to couplers.
Switch interface
Connect a retractive switch for on / off / dimming control. Multiple switchinterface modules may be connected for
twoway switching.
Note: available as “master” and “slave” versions.
Power hub
Coupler
Emergency 3 hour module
Sensor
iBus
RJ-11 cables and connector
Switch interface